NSW - QLD - SA - TAS - VIC - WA

SALES SUPPORT CLICK HERE
SERVICE SUPPORT CLICK HERE

ARM290BI AUTOMATIC GATE OPERATOR

12 VOLT ELECTRIC GATE OPERATOR - RESIDENTIAL / COMMERCIAL - 6.0 METRE LEAF

Manufactured by TAU in Italy the ARM290BI is a high quality, powerful 12 volt (actually an 18 volt motor but labeled 12 volt so as not to cause confusion) swing gate electro mechanical operator. This swing gate motor is a perfect example of a commercial operator designed to be also acceptable to high end residential installations. The ARM290BI uses minimum side room and is suitable for gates up to 6.0 metres wide. The ARM290BI is a self locking operator with key operated manual override but one of the main benefits of the low voltage motor is the ability to use battery backup meaning you may never have to use the manual override key. The ARM290BI is a perfect example of you get what you pay for in that it is slightly more expensive than some of it's similar rated cousins but then it boasts a number of features not found on the less expensive models and the build quality is obvious. Internally the ARM290BI is all metal quality build and has a built in optical encoder.

It is possible to use a variety of control boards to control the ARM290BI but the to take advantage of the optical encoder technology the preferred board is the LOGICTAUD749 which can be used as a one or two motor controller. The LOGICTAUD749 has inputs for the encoder, slow down mode, all your safety input features and battery backup is available. The LOGICTAUD749 like all TAU product is robust and tough whilst simple to use. Complete the TAU picture with TAU remote controls that work with the built in receiver card. Keep the quality throughout.
You can watch a good video of the ARM250 in action here.

ARM290BI -

Single motor with built in optical encoder.

$1537.00

LOGICTAUD749MA -

Logic control for one or two motors with receiver.

$725.00

REMTAU -

4 channel 433mhz key ring style remote control.

$66.00

TAUKEYPAD -

TAU wireless outdoor keypad

$268.00

DIAMONDBATT -

Battery leads for TAU control board. (Requires 9ah battery)

$7.30

SOLAR12.25.26KIT -

25W panel, 26ah battery, regulator

$348.00

OUTSWING -

Zinc dipped 8mm solid steel outswing bracket

$77.00

Motor Voltage -

12 volts DC

Current Standby -

0mA

Current at use -

1.0A

Motor power -

120W

Maximum thrust -

2600Nm

Opening Time 90 degrees -

21 seconds

Maximum gate width -

6000 mm

Duty cycle -

100%

Height -

122mm

Width -

99mm

Length -

1441mm

Weight -

7.0 Kg

IP rating -

IP44

ARMPOSTKIT - The ARM270240 is supplied with a weld on post bracket considered necessary for the size of gate the motor is designed for. It is possible to purchase a spare part known as ARMPOSTKIT which consists of two bolt together plates that with oyu weld on bracket make the installation weld free.

PHOTOCELLS - A must have if you use automatic closing function is photocells. Photocells provide an extra level of safety to prevent gates from closing on vehicles or pedestrians. Sliding gates can have a single set between the gate posts or multiple sets if desired at various heights. More information and a full list of product here.

ELECTRIC GATE LOCK - There is varied debate about when an automatic gate should have the extra security of an electric gate lock. The lock increases security and also protects your gate operating system. It operates automatically when you choose to open your gate. Check them out here.

 

NSW - QLD - SA - TAS - VIC - WA